STATUS TWIN 2-GANG SURFACE-MOUNTED BACK/WALL PATTRESS BOX 25MM

How to Use the STATUS TWIN 2 GANG SURFACE MOUNTED BACK / WALL PATTRESS BOX 25MM

Introduction

The STATUS TWIN 2 GANG SURFACE MOUNTED BACK / WALL PATTRESS BOX is designed for use in electrical installations. It is a foundational component used to mount electrical outlets or switches on a surface.

Tools Required

• Drill
• Screwdriver
• Spirit level
• Measuring tape
• Pencil for marking

Installation Steps

Step 1: Prepare the Surface

• Identify the location where the pattress box will be mounted.
• Ensure the surface is clean and dry.
• Use a spirit level to ensure alignment.

Step 2: Mark the Position

• Place the pattress box against the wall at the desired location.
• Use a pencil to mark the drilling points through the mounting holes of the box.

Step 3: Drill Holes

• Use a drill to create holes at the marked points.
• Ensure the holes are appropriate for wall plugs if needed.

Step 4: Secure the Pattress Box

• Align the pattress box with the drilled holes.
• Insert screws through the mounting holes and tighten them securely into the wall.
• Ensure the box is firmly fixed and level.

Step 5: Install Wiring and Accessories

• Turn off the power supply to the circuit you are working on.
• Feed the electrical cables through the cable entries in the pattress box.
• Connect the wiring to the appropriate terminals of your electrical accessory (e.g., switch, socket).
• Secure the accessory to the pattress box using screws.

Step 6: Final Checks

• Ensure all connections are tight and secure.
• Restore power and test the installed accessory for proper operation.

Safety Tips

• Always turn off the power at the circuit breaker before starting any electrical work.
• If unsure, consult a qualified electrician to perform the installation.