Securit S8306 Bright Panel Pins 1.6 x 25mm, 80g

Description

How to Use SECURIT S8306 Panel Pins Bright 1.6 x 25mm 80g

Introduction

The SECURIT S8306 Panel Pins are small nails used for light woodworking tasks. They are ideal for securing thin panels or moldings. Follow the instructions below to use them effectively.

Tools Required

• Hammer
• Pencil (for marking)
• Ruler or measuring tape

Steps to Use

Step 1: Measure and Mark

1. Use a ruler or measuring tape to determine where you need to place the panel pins.
2. Mark the spots lightly with a pencil to guide your nailing.

Step 2: Position the Pin

1. Hold the panel pin between your thumb and forefinger.
2. Place the point of the pin on the marked spot.

Step 3: Hammer the Pin

1. Gently tap the head of the panel pin with a hammer to start it into the wood.
2. Ensure the pin is entering at the correct angle to avoid bending.
3. Continue hammering until the head of the pin is flush with the surface of the wood.

Step 4: Repeat as Needed

1. Repeat the above steps for each additional pin needed for your project.
2. Ensure even spacing for a secure and professional finish.

Safety Tips

• Always wear safety goggles to protect your eyes when using a hammer.
• Keep fingers clear of the hammer’s path to prevent injury.

Conclusion

Using SECURIT S8306 Panel Pins is a straightforward process. With careful measuring and gentle hammering, you can effectively secure panels and moldings for your woodworking projects.