ORACSTAR PRO082 40MM PUSHFIT 90-DEGREE ELBOW

How to Use the ORACSTAR PRO082 PUSHFIT 90 DEG BEND 40MM

Introduction

The ORACSTAR PRO082 Pushfit 90 Degree Bend 40mm is designed for easy installation in plumbing systems. Follow the steps below for a successful installation.

Materials Needed

• ORACSTAR PRO082 Pushfit 90 Degree Bend 40mm
• Compatible pipes (40mm diameter)
• Pipe cutter or saw
• Marker pen
• Cleaning cloth

Step-by-Step Instructions

1. Prepare the Pipes

• Measure and mark the length of the pipe to be cut, ensuring it fits your system design.
• Use a pipe cutter or saw to cut the pipes to the required length.
• Ensure all cuts are straight and clean, without any burrs or rough edges.
• Wipe the ends of the pipes with a cleaning cloth to remove any debris or dust.

2. Connect the Pipes

• Take the ORACSTAR PRO082 Pushfit 90 Degree Bend and inspect it for any damage.
• Align one end of the cut pipe with one opening of the pushfit bend.
• Firmly push the pipe into the fitting until it reaches the stop inside the fitting.
• Repeat the process for the other pipe on the opposite side of the bend.

3. Check the Installation

• Ensure both pipes are fully inserted and secure within the bend fitting.
• Visually inspect the connection to ensure there are no gaps or misalignments.
• Run water through the system to check for any leaks at the connection points.

Tips for Best Results

• Ensure the pipes are cut to the correct length to prevent strain on the fittings.
• Always double-check the fit before finalizing the installation.
• If a leak is detected, remove and refit the pipes to ensure a secure connection.