ORACSTAR PRO081 32MM PUSH-FIT 90-DEGREE ELBOW

Description

How to Use the ORACSTAR PRO081 PUSHFIT 90 DEG BEND 32MM

Introduction

The ORACSTAR PRO081 PUSHFIT 90 DEG BEND 32MM is a plumbing fitting designed for easy installation. It allows you to create a 90-degree bend in your pipe system without the need for soldering or glue.

Tools Needed

• Pipe cutter or hacksaw
• Deburring tool or sandpaper
• Marker pen

Steps to Install

Step 1: Prepare the Pipe

1. Measure and mark the length of pipe needed using a marker pen.
2. Cut the pipe to the required length using a pipe cutter or hacksaw.
3. Use a deburring tool or sandpaper to smooth the cut edges, ensuring there are no sharp edges that could damage the fitting.

Step 2: Insert the Pipe into the Fitting

1. Ensure the pipe is clean and free from debris.
2. Push the pipe end into the ORACSTAR PRO081 fitting until it reaches the internal stop.
3. Ensure the connection is secure by gently pulling on the pipe; it should not come out easily.

Step 3: Check for Leaks

1. Turn on the water supply to the pipe system.
2. Inspect the joint for any leaks.
3. If leaks are detected, ensure the pipe is fully inserted into the fitting and check again.

Maintenance Tips

• Regularly check the fitting for signs of wear or damage.
• If a leak develops, consider replacing the fitting to ensure a secure connection.

Safety Precautions

• Ensure you are familiar with your local plumbing codes and standards before installation.
• Wear appropriate safety gear, such as gloves and goggles, when cutting and handling pipes.