FAST PAK VALUE 5298 M6 x 80 Nylon Hammer Fixings, Pack of 5

Description

How to Use FAST PAK VALUE 5298 M6 X 80 Nylon Hammer Fixings

Introduction

FAST PAK VALUE 5298 M6 X 80 Nylon Hammer Fixings are designed for securing materials to concrete, brick, or other solid surfaces. Follow these instructions to safely and effectively use the fixings.

Materials Needed

• FAST PAK VALUE 5298 M6 X 80 Nylon Hammer Fixings
• Drill with appropriate drill bit (6mm bit recommended)
• Hammer
• Screwdriver (if needed)
• Protective eyewear

Steps to Use

1. Prepare the Surface: Ensure the surface where you will be placing the fixings is clean and free of debris.
2. Drill the Hole:
   • Put on protective eyewear.
   • Use a 6mm drill bit to drill a hole into the surface at the desired location. The hole should be at least 80mm deep to accommodate the fixing.
3. Insert the Fixing:
   • Place the nylon hammer fixing into the pre-drilled hole.
   • Ensure it is aligned correctly and sits flush with the surface.
4. Secure the Fixing:
   • Using a hammer, tap the nail or pin of the fixing until it is fully driven into the anchor.
   • Make sure the fixing is tight and secure.
5. Check Stability:
   • Ensure the fixing is firmly in place and can hold the intended load.
   • Adjust or replace if necessary.

Tips for Best Results

• Always wear protective gear when drilling and hammering.
• Use the correct drill bit size to avoid damaging the fixing or the surface.
• Test the stability before applying full load to the fixings.

Safety Precautions

• Keep away from children.
• Do not overload the fixings beyond their intended capacity.
• Ensure proper ventilation if using in dusty environments.