FAST PAK VALUE 1512 7.0MM ROUND BROWN CABLE CLIPS, PACK OF 30

How to Use FAST PAK VALUE 1512 7.0MM Cable Clips

Introduction

The FAST PAK VALUE 1512 Cable Clips are used to secure cables neatly and safely in place. This guide will help beginners use them effectively.

Tools Required

• Hammer
• Measuring Tape
• Pencil or Marker

Step-by-Step Instructions

1. Plan Your Cable Route

• Determine the path where the cable will be installed.
• Ensure that the cable route is clear of any obstacles.

2. Measure and Mark

• Use a measuring tape to measure the distance between each cable clip. A typical spacing is 30-50 cm apart.
• Mark the spots on the wall or surface where you will place each clip using a pencil or marker.

3. Position the Cable Clips

• Align the cable clip on the marked spot.
• Ensure the clip is sized correctly for the cable; in this case, it should fit a 7.0mm cable snugly.

4. Secure the Cable Clips

• Hold the cable clip in place and gently hammer the nail into the wall or surface.
• Be careful not to hammer too hard to avoid damaging the cable or clip.

5. Insert the Cable

• Slide the cable into each clip, ensuring it sits securely without being pinched or damaged.

Tips for Best Results

• Check that all clips are securely fastened before inserting the cable.
• Use additional clips for more support if the cable is heavy or in high-traffic areas.

Safety Precautions

• Ensure the surface you are hammering into is safe and does not hide electrical wires or pipes.
• Wear safety goggles to protect your eyes during installation.

Conclusion

By following these steps, you can effectively use the FAST PAK VALUE 1512 Cable Clips to organize and secure your cables neatly.