ERA Tubular Mortice Latch 75mm / 3 Inch in Polished Brass Finish

How to Use the ERA Tubular Mortice Latch 75mm / 3 Inch Polished Brass

Introduction

The ERA Tubular Mortice Latch is designed for use on internal doors to provide a reliable and secure latch mechanism. Follow these steps to ensure proper installation and use.

Tools Required

• Drill
• Screwdriver
• Chisel
• Measuring tape
• Pencil

Installation Instructions

Step 1: Prepare the Door

• Measure the desired height for the latch on the door edge and mark it with a pencil.
• Drill a hole of appropriate diameter through the side edge of the door where the latch will be installed.

Step 2: Install the Latch

• Insert the latch into the drilled hole, ensuring that the latch plate is flush with the door edge.
• Mark the screw holes for the latch plate, then remove the latch.
• Chisel out a recess for the latch plate to sit flush with the door edge.
• Reinsert the latch and secure it with screws.

Step 3: Install the Strike Plate

• Close the door to mark where the latch hits the door frame.
• Drill a hole in the frame to accommodate the latch bolt.
• Align the strike plate over the hole, mark the screw positions, and chisel out a recess for the strike plate.
• Secure the strike plate with screws.

Usage Tips

• Ensure the latch operates smoothly by testing it several times after installation.
• If the latch does not align properly with the strike plate, adjust the position of the strike plate slightly.

Maintenance

• Periodically check the screws to ensure they are tight and secure.
• Lubricate the latch mechanism occasionally to maintain smooth operation.