Draper Expert Masonry Drill Bits 6.5 x 100mm 39766

Description

How to Use DRAPER EXPERT 39766 6.5 X 100MM Masonry Drill Bits

Materials Needed

• DRAPER EXPERT 39766 6.5 x 100mm Masonry Drill Bit
• Drill (compatible with masonry drill bits)
• Protective eyewear
• Dust mask
• Work gloves
• Measuring tape or ruler
• Pencil or marker for marking

Preparation

1. Put on protective eyewear, dust mask, and work gloves to ensure safety.
2. Use a measuring tape or ruler to determine the exact location where you need to drill.
3. Mark the spot with a pencil or marker.
4. Ensure your drill is in good working condition and is compatible with masonry drill bits.

Drilling Process

1. Securely insert the DRAPER EXPERT 39766 Masonry Drill Bit into your drill, ensuring it’s tight and properly seated.
2. Set the drill to the appropriate speed for masonry work, typically a lower speed for better control.
3. Align the drill bit with your marked spot on the masonry surface.
4. Apply steady pressure and begin drilling slowly to create a guide hole.
5. Once the guide hole is established, increase speed slightly and continue drilling to the desired depth.
6. Periodically pull the drill bit out to clear debris from the hole.

After Drilling

1. Turn off the drill and remove the bit carefully.
2. Clean the drill bit with a dry cloth to remove any dust or debris.
3. Inspect the masonry surface and the hole drilled to ensure it meets your requirements.
4. Store the drill bit in a safe, dry place to prevent damage and corrosion.

Safety Tips

• Always wear protective gear to avoid injury from flying debris.
• Ensure the drill is unplugged or turned off when changing bits.
• Keep hands and fingers clear of the drill bit during operation.
• Do not apply excessive force; let the drill bit do the work.