DRAPER EXPERT 40830 SDS+ MASONRY DRILL BIT, 6.0 X 110MM

How to Use the DRAPER EXPERT 40830 6.0 X 110MM SDS+ Masonry Drill Bit

Introduction

The DRAPER EXPERT 40830 is a high-quality masonry drill bit designed for drilling into concrete, brick, and other hard materials. Follow these steps to use the drill bit effectively and safely.

Tools and Materials Needed

• DRAPER EXPERT 40830 6.0 X 110MM SDS+ Masonry Drill Bit
• SDS+ compatible drill
• Protective eyewear
• Dust mask (optional)
• Gloves (optional)
• Marker or pencil

Preparation

1. Inspect the drill bit for any damage or defects before use.
2. Ensure your drill is compatible with SDS+ drill bits.
3. Wear protective eyewear and other safety gear as needed.
4. Mark the drilling point on the work surface with a pencil or marker.

Drilling

1. Insert the DRAPER EXPERT drill bit into the SDS+ chuck of your drill.
2. Secure the bit in place by turning the chuck until it is firmly locked.
3. Set the drill to hammer mode for optimal performance on masonry surfaces.
4. Align the drill bit with the marked point on the surface.
5. Start the drill at a low speed to begin the hole, applying steady pressure.
6. Increase the speed gradually while maintaining control of the drill.
7. Drill to the desired depth, frequently withdrawing the bit to clear debris.

After Use

1. Turn off the drill and remove the drill bit from the chuck.
2. Clean the drill bit with a cloth to remove dust and debris.
3. Store the drill bit in a dry place to prevent rust and damage.

Safety Tips

• Always wear protective eyewear when drilling.
• Ensure the drill bit is properly secured before use.
• Do not apply excessive force to the drill; let the tool do the work.
• Keep hands and loose clothing away from the moving drill bit.