Draper Expert 40825 SDS+ Masonry Drill Bit, 5.0 x 110mm

How to Use the DRAPER EXPERT 40825 5.0 X 110MM SDS+ Masonry Drill Bit

Step-by-Step Instructions

1. Gather Necessary Tools and Equipment

• DRAPER EXPERT 40825 5.0 X 110MM SDS+ Masonry Drill Bit
• SDS+ compatible drill
• Safety goggles
• Dust mask
• Ear protection
• Work gloves

2. Prepare the Workspace

• Clear the area of any debris or obstacles.
• Ensure adequate lighting for visibility.
• Check for any hidden electrical wires or plumbing behind the drilling surface.

3. Safety First

• Put on safety goggles to protect your eyes.
• Wear a dust mask to avoid inhaling dust particles.
• Use ear protection to safeguard against loud noise.
• Wear work gloves to protect your hands.

4. Insert the Drill Bit

• Ensure the drill is powered off and unplugged.
• Insert the DRAPER EXPERT drill bit into the SDS+ chuck of your drill.
• Secure the bit by turning the chuck until it is tightly in place.

5. Drilling

• Plug in the drill and switch it to the hammer drill setting.
• Position the drill bit on the desired drilling point on the masonry surface.
• Apply steady pressure as you begin drilling, ensuring to keep the drill perpendicular to the surface.
• Drill to the required depth, withdrawing the bit periodically to remove debris.

6. After Drilling

• Turn off and unplug the drill.
• Carefully remove the drill bit from the drill chuck.
• Clean the drill bit and store it properly for future use.
• Clear any debris from the workspace.

7. Additional Tips

• Ensure the drill is set to the correct speed for masonry drilling.
• Use a depth stop if available on your drill for consistent hole depths.
• Regularly check the drill bit for wear and replace if necessary.