DRAPER 14188 7MM X 150MM TCT MASONRY DRILL BIT

Description

How to Use the DRAPER 14188 TCT Masonry Drill Bit 7mm x 150mm

This guide will walk you through the basic steps to effectively use the DRAPER 14188 TCT Masonry Drill Bit for drilling into masonry surfaces.

Step 1: Gather Your Materials

• DRAPER 14188 TCT Masonry Drill Bit 7mm x 150mm
• Drill machine compatible with 7mm drill bits
• Safety goggles
• Dust mask
• Protective gloves

Step 2: Prepare for Drilling

• Put on your safety goggles, dust mask, and protective gloves to ensure safety.
• Ensure the drill is turned off and unplugged when attaching the drill bit.
• Insert the DRAPER 14188 TCT Masonry Drill Bit into the drill’s chuck and tighten securely.

Step 3: Mark the Drilling Spot

• Use a pencil or marker to indicate the exact spot on the masonry where you intend to drill.
• If necessary, use a center punch to create a small indentation at the marked spot to prevent the drill bit from slipping.

Step 4: Drill the Hole

• Set the drill machine to the hammer or percussion mode for masonry drilling.
• Align the drill bit with the marked spot on the surface.
• Start the drill at a slow speed to ensure precision.
• Gradually increase the speed, applying steady pressure without forcing the drill.
• Drill to the desired depth while occasionally retracting the drill bit to remove debris and reduce friction.

Step 5: Finish Up

• Once the desired depth is reached, gently retract the drill bit from the hole.
• Turn off the drill and remove the drill bit if needed.
• Clean the area of any dust or debris.

Always follow safety precautions and refer to the drill and drill bit manufacturer’s instructions for specific guidance.