DRAPER 14143 DBMS 6mm x 100mm Masonry Drill Bit

Description

How to Use the DRAPER 14143 DBMS Masonry Drill Bit 6 x 100mm

Introduction

The DRAPER 14143 DBMS Masonry Drill Bit is designed for drilling into masonry and concrete surfaces. Follow these instructions to ensure safe and effective use.

Tools Required

• Drill machine (with hammer function if available)
• Protective eyewear
• Dust mask
• Measuring tape
• Pencil or marker

Safety Precautions

• Always wear protective eyewear to shield your eyes from debris.
• Use a dust mask to avoid inhaling dust particles.
• Ensure the drill machine is in good working condition.
• Secure the material you are drilling to prevent slipping.

Steps to Use

1. Measure and Mark: Use a measuring tape to determine the exact spot where you need to drill. Mark the spot with a pencil or marker.
2. Prepare the Drill: Insert the DRAPER 14143 DBMS Masonry Drill Bit into the drill chuck. Tighten it securely.
3. Set the Drill: If your drill has a hammer function, enable it for better efficiency in masonry.
4. Drill the Hole: Position the drill bit on the marked spot. Start drilling at a slow speed to create a pilot hole, then gradually increase the speed. Apply steady pressure but avoid forcing the drill bit.
5. Clear Debris: Periodically pull the drill bit out to clear debris from the hole. This will prevent overheating and ensure a clean hole.
6. Finish: Once the desired depth is reached, stop the drill and carefully remove the bit from the hole.

After Use

• Turn off and unplug the drill.
• Remove the drill bit and clean it with a dry cloth.
• Store the drill bit in a safe, dry place to prevent rust.

Troubleshooting

• If the drill bit is not penetrating, ensure it is securely fastened in the chuck and the drill is set to the correct mode.
• If overheating occurs, allow the bit to cool before continuing.