National Abrasives Coarse Red Anti-Oxide Flexi-Backed Roll, 1m x 115mm

How to Use the National Abrasives Flexi Backed Red Anti-Oxide Coarse Roll

Introduction

The National Abrasives Flexi Backed Red Anti-Oxide Coarse Roll is designed for sanding and surface preparation. Follow these steps to ensure effective and safe use.

Materials Needed

• National Abrasives Flexi Backed Red Anti-Oxide Coarse Roll
• Sanding block or holder
• Protective gloves
• Protective eyewear
• Dust mask

Preparation

1. Ensure you are working in a well-ventilated area.
2. Wear appropriate safety gear, including gloves, eyewear, and a dust mask.

Cutting the Sandpaper

1. Unroll the sandpaper to the desired length.
2. Use scissors or a utility knife to cut the sandpaper to the appropriate size for your sanding block or holder.

Attaching to a Sanding Block

1. Wrap the cut piece of sandpaper around your sanding block or attach it securely to your holder.
2. Ensure the sandpaper is tight and flat against the surface of the block to avoid uneven sanding.

Sanding the Surface

1. Begin sanding the surface in a consistent, circular motion to prevent scratches and ensure even abrasion.
2. Apply even pressure; avoid pressing too hard to extend the life of the sandpaper.
3. Periodically check the surface to assess progress and adjust the pressure or motion as needed.

Finishing Up

1. Once the desired finish is achieved, stop sanding and wipe down the surface with a clean cloth to remove dust.
2. Dispose of used sandpaper responsibly.

Note

This product is intended for users over the age of 18. Please confirm your age before purchasing or using this product.