ORACSTAR 3/4″ Hose Union Washers, Pack of 5

How to Use the ORACSTAR Hose Union Washer 3/4″ 5/PK

Introduction

The ORACSTAR Hose Union Washer is designed to provide a tight seal for hose connections. This guide will help beginners understand how to use these washers effectively.

Materials Needed

• ORACSTAR Hose Union Washer 3/4″ 5/PK
• Garden hose or fitting with a 3/4-inch connection
• Adjustable wrench (optional)

Steps to Install the Washer

1. Turn Off Water Supply: Before installing the washer, ensure that the water supply is turned off to avoid any leaks or spills.
2. Disconnect the Hose: Unscrew the hose from the tap or fitting where the washer needs to be installed.
3. Remove Old Washer: If there is an old washer in the hose connection, remove it carefully.
4. Install New Washer: Place the new ORACSTAR washer into the hose fitting. Make sure it sits flat and aligned properly.
5. Reconnect the Hose: Screw the hose back onto the tap or fitting. Ensure it is tightened securely to prevent leaks. You can use an adjustable wrench if needed, but avoid over-tightening.
6. Test the Connection: Turn the water supply back on and check for any leaks. If there are leaks, tighten the connection further.

Maintenance Tips

• Regularly check for wear and tear on the washer and replace it if necessary.
• Ensure connections are always tight to prevent water wastage.

Safety Precautions

• Ensure the water supply is turned off before disconnecting any hoses.
• Wear gloves if needed to protect your hands during installation.