STATUS FSU Fluorescent Starter 4-65W, Pack of 2

How to Use the STATUS FSU Fluorescent Starter 4-65W 2/PK

Introduction

The STATUS FSU Fluorescent Starter is designed for use with fluorescent tubes ranging from 4 to 65 watts. Follow the steps below to ensure proper installation and operation.

Safety Precautions

• Ensure the power is turned off before beginning any installation.
• Confirm the starter is compatible with your fluorescent tube wattage.
• Handle the starter with care to avoid breakage.

Installation Instructions

Step 1: Turn Off the Power

• Switch off the power supply to the light fixture at the main electrical panel.
• Ensure the light fixture is not live by testing with a non-contact voltage tester.

Step 2: Remove the Old Starter

• Locate the starter at one end of the fluorescent tube.
• Gently twist the old starter counter-clockwise to remove it from the socket.

Step 3: Install the New Starter

• Insert the new STATUS FSU starter into the socket.
• Twist the starter clockwise until it is securely in place.

Step 4: Restore Power

• Return to the main electrical panel and switch the power supply back on.
• Turn on the light fixture to ensure the new starter is functioning correctly.

Troubleshooting Tips

• If the fluorescent tube does not light, check that the starter is properly installed.
• Ensure the fluorescent tube itself is in working condition.
• If issues persist, consult a qualified electrician for assistance.

Conclusion

By following these instructions, you should be able to successfully install and use your STATUS FSU Fluorescent Starter. Always remember to follow safety precautions and consult a professional if needed.